UNIT RESET INSTRUCTIONS
Follow these instructions to reset the lifting system on your table or workstation.
Skip to content
Do you have a Simple Hand Switch?
LOWER THE UNIT TO IT’S LOWEST POINT
Then release DOWN button
PRESS AND HOLD DOWN BUTTON
Hold for at least 10 seconds or until there is a slight movement.
Then release DOWN button
SYSTEM SHOULD NOW FUNCTION NORMALLY
If the DOWN button is released too early, this could lead to a malfunction; then this process would need to be repeated from the beginning.
Do you have a Programmable Hand Switch?
LOWER THE UNIT TO IT’S LOWEST POINT
Then release DOWN button
Press and hold 1, 2 and UP buttons
Hold for 5-8 seconds until the display shows S5. The system has recognized the RESET command.
Then tap the DOWN button
The switch should now display S0.
Press the green S button to save
You may hear clicking sounds as the system resets. The switch may display E61.
Press and hold DOWN button.
Reinitialize the system by holding the down button for 10-15 seconds. Switch should display either 027 or 001.
Then release DOWN button
SYSTEM SHOULD NOW FUNCTION NORMALLY
If the system does not function as described, please contact us at info@builtsystems.net or call 616-795-4569.